油动机(国外英文资料).docVIP

油动机(国外英文资料) Oil motive The oil motive is the actuator of the regulating valve, which will be converted by a secondary oil signal input by an amplifier or electro-hydraulic converter The output of the stroke is sufficient to control the valve and control the steam turbine. The oil motivation is the motive of the double action reciprocating oil, which is the working medium of steam turbine oil, and the power oil is applied to the pressure of ~ 0.8 Mpa Force of oil. The oil motivation structure is shown in figure 1. 1. The pull rod Adjusting bolt 3. The feedback on board 4. The piston rod Cylinder cover 6. The piston 7. Connect body The wrong accelerator Shell) Feedback lever Adjusting screw Adjusting nut Angle lever Pole end joint bearing Figure 1 oil motive The oil motive consists mainly of cylinder, fault throttle, connectome and feedback mechanism. The wrong accelerator (8) is connected by the connecting body (7) to the cylinder (5), and the oil circuit between the wrong accelerator and the cylinder is connected Connect the body, the oil circuit is sealed with o-ring. There are two kinds of casting and forgings, the form of casting. The cylinder is composed of base, cylinder, cylinder head, piston and piston rod. The cylinder and base and cylinder cover are o-shaped Enveloping, they are assembled by four long bolts. The piston is fitted with a special piston ring filled with ptfe. The piston moves A damped area of ~ 10mm near the dead point is used to reduce the inertia force and load force of the piston and reduce the speed of the piston. The cylinder lid is equipped with piston rod sealing component, the top is equipped with piston rod guide and Angle lever support. The cylinder depends on the lower part of the base of the base and the joint bearing on the bracket, the pin shaft connection and the support on the bracket. In the oil cylinder piston The pole (4) has the pull rod (1) and the rod end joint bearing (13), through (13) the oil cylinder and the regulati