美能达bizhub 163v复印机维修呼唤M2(国外英文资料).docVIP

美能达bizhub 163v复印机维修呼唤M2(国外英文资料) minolta 163 Maintenance call appears in the photocopier 2 Utility - Stop - 0 0 - Stop - 0 one To finish quickly, the display panel becomes English [maintenance mode] Im going to go up and down to the ninth. The clean The data According to the OK And Im going to go up and down, and Im going to choose the fourth term. supplies life Counter atdc According to the OK Then turn off the phone and turn on the call maintenance. 2 No. Service call 2 It is the counter due to replace the drum and the carrier, but generally not 10 You dont have to change it. one You press the utility key first, and you press the stop button - Two zero - Stop button - a 0 a one Come out and click on it The arrow Choose the ninth item In the press YES And then choose to SUP Thats the long one that starts yes then The number shown above The value should be a negative number YES , that is good. 2 , According to the Remove - 00 - remove - 01 In the maintenance mode, Choose the first 9 Item, According to the OK, And then the fourth term, According to the OK , Can be removed. minolta 220, 163, Maintenance call M2 ( Or maintenance call 2) The solution Utility key -- stop 0 -- 0 -- stop - 0-1 Choose the ninth item: The clear data According to the OK Select item 5: Supplies counter According to the OK Zero, restart the copier. COF32 is ATDC And the sensor (that is, the iron ratio imbalance) Enter maintenance mode: utility key - stop - 0-0 - stop 0-1 After entering to choose 5 , The FUNCTION (functional mode) press YES key Enter the choice. ATDC AUTO ADJUST According to the copy button Note: this is an automatic adjustment of iron powder, which is one when automatic tuning cannot be done Make sure you adjust it manually What percentage of iron powder do you want to see? More than 160 It must be wrong. It is. You have to slow down. But a dont Dont be too large, usually 150 Im sure I can solve this code problem These problems have been encountered N Times. It is. Sen