课程设计单级圆柱减速器(国外英文资料).docVIP

课程设计单级圆柱减速器(国外英文资料) Look at the [1] table 10 minus 3, which is K alpha = 0.94; Check [1] table 10-4 KL = 0.99 Z is equal to PC over [P1 + delta P1) K alpha K. = 3.3 / [1.4 + 0.17] * 0.94 * 0.99] = 2.26 (3) (6) calculating the pressure on the shaft From the textbook [1] table 10-5, check q = 0.1 kg/m, which is the initial pull of the textbook (10-20) single V belt: F0 = 500PC/ZV [2.5 / K alpha] -1] + qV2 = 500x3. 3/3x7.06 (2.5/0.94-1) + 0.10 x7.062 = 134.3 kN The pressure FQ is applied to the bearing FQ = 2ZF0sin (alpha 1/2) = 2 * 3 * 134.3 sin (158.67 o / 2) N = 791.9 The design calculation of gear transmission (1) select gear materials and heat treatment: the gears drive is a closed drive, usually The gears are made of soft teeth. Refer to table [1], 6-8, for materials that are cheap and easy to make, and the small gear materials are 45 steels, the quality of the adjustment, the surface hardness 260HBS; The big gear is also made of 45 steel and is being treated with a hardness of 215HBS; Precision grade: the transport plane is the general machine, the speed is not high, so choose the grade 8 accuracy. (2) contact fatigue strength design on the surface of the teeth D1 is greater than or equal to (6712 times kT1 (u + 1)/phi du [sigma H] 2) 1/3 To determine the relevant parameters: the transmission ratio I tooth = 3.89 Take the pinion, Z1 = 20. The number of gear teeth: Z2 = iZ1 = x 20 = 77.8 and Z2 = 78 Take phi d = 1.1 from the textbook table 6-12 (3) torque T1 T1 is equal to 9.55 times 106 times P1 over n1 is equal to 9.55 times 106 times 2.61 divided by 473.33 is equal to 52660N. mm (4) loading coefficient k: k = 1.2 (5) xus contact stress [sigma H] [sigma H] = sigma Hlim ZN/SHmin is from the textbook [1], 6-37. Sigma Hlim1 = 610 mpa sigma Hlim2 = 500 mpa Contact fatigue life coefficient Zn: in the year 300 working days, 16h calculations per day, calculated by the formula N = 60njtn N1 is equal to 60 times 473.33 times 10 times 300 times 18 is 1.36 x109 N2 = N/I =