调速皮带称准动态实物标定方法(国外英文资料).docVIP

调速皮带称准动态实物标定方法(国外英文资料) The quasi-dynamic object calibration method of the speed regulating belt scale In order to ensure the weighing accuracy of the belt scale, a physical calibration should be carried out every three months in the course of use. For a small number of cement plants with a by-pass or on-line calibration system, the calibration is simple and easy. But most factories do not have such a condition, and can only adopt artificial means to carry out the on-site object calibration. In order to accurately measure the per unit time after speed belt scale materials, artificial physical calibration need to intercept after belt scale of material, so need to manipulate space, do not have material conditions of the factory on the spot, the artificial physical calibration is very difficult, or not. Even if a factory has a condition, it is required to weigh the intercepted material and then send it to the production line. Besides physical calibration is often not a can make the belt scale precision to meet the requirements of error range, to complete, but after several calibration calibration every increase in the number of work has doubled. So artificial object calibration is not only restricted by field space, but also a very complicated and heavy work. For the above reason, in practice, many cement plants seldom demand regular dynamic object calibration on the speed adjustment belt scale. In order to seek a simple and feasible, which can replace the traditional physical calibration, and the effect is the same way, many measuring workers have long a lot of exploration. For example, the chain code calibration method is one example. The link code calibration method is closer to dynamic object calibration than dynamic weight calibration, but it still cant replace dynamic object calibration. Developed by combining our CL - 1 type weighing belt scale controller (the controller can control the slip speed scale, frequency control of motor speed, scale, spiral scales, co