谈谈钻孔灌注桩的施工体会(国外英文资料).docVIP

谈谈钻孔灌注桩的施工体会(国外英文资料) As a kind of basic bearing structure and foundation supporting structure, bored pile is the technology content that is widely used in construction construction. However, the internal quality of the bored pile is invisible, and it is impossible to observe the internal quality of the pile, and it is not realistic for the cost and the period of construction. Therefore, generally in the construction of it as a key project, and select team of excellent construction technology, to improve the quality of construction process management, grasp and construction problems that may occur in the process of analysis. Eliminate all bad risks before they become piles. The main problems of the construction process of bored piles are discussed, and the experience and experience are discussed. One, the control of the hole quality It is an important process in the construction of concrete grouting pile, and its quality control will directly affect the bearing capacity of pile and pile. Therefore, the construction technology and construction quality control should focus on the following tasks. 1, use the septum construction procedure. The bored pile is made into a hole and then piled in the hole. The hole stage is balanced by mud, and the surrounding soil is loose when the pile is drilled. It is a safe technical measure to prevent the hole and the shrinkage diameter. The vertical degree of the hole. The vertical degree of the bored pile is an important link to guarantee the stability of the base bearing capacity and the stability of the structure and the accuracy of the building dimensions. The main reason for the inclined hole or bent hole is: the position stability of the rig, the vibration of the drill, or the bending of the drill pipe. When the ground is weak or uneven; The soil layers are either oblique or large in the soil or other hard objects. In these cases, the preparation must be carefully prepared before construction, and the ground will be leveled and