路由器常用命令(国外英文资料).docVIP

路由器常用命令(国外英文资料) Routers are commonly used commands 1, the Exec commands: 1-99 resumes a session Bfe manual emergency mode Settings The clear reset function Clock management system clock Configure enters the setup mode Connect opens a terminal Copy sets the file from the TFTP server or copies the Settings file to the TFTP server The debug debugging Disable exit the command status Disconnect disconnect a network connection Enable enter the command status Erase erase flash memory The exit exit excel model Help interactive help system description Lat opens a local transport connection The lock locking terminal Login is logged in as a user name Logout from the terminal Mbranch tracks multiple routing broadcasts to the trees lower end branch Mrbranch tracks the reverse multi-route broadcast to the trees upper branch Name-connection names an existing network connection No closes the debug function The pad opens the x.29 pad connection Ping sends back the explicit information PPP starts point-to-point connection protocol Reload is down and the execution is cold Resume resumes an active network connection Rlogin opens the remote registry connection RSH performs a remote command Send sends information to another terminal Setup to run setup command Show shows that the system information is running Slip began to slip agreement Start - chat performs the dialog on the command line Systat displays information about the terminal line Telnet remote login Terminal line parameters Test test subsystem memory and port Tn3270 opens a tin3270 connection Trace tracing is routed to the destination Undebug exits the debug function Verify verifies the total number of blinking files Where the connection of the activity is displayed Which - route performs the OSI routing table lookup and displays the results Write writes the running Settings to the memory, network, or terminal X3 sets the x.3 parameter on the PAD Xremote into xremote mode # 2, the show? Access-expression displays access contr