N300R说明书（国外英文资料）.doc

N300R说明书（国外英文资料） 1.4 installation flowchart Chapter ii hardware installation 2.1 panel indicator: The ipTIME N300R front panel diagram The back panel has five mesh ports, one WAN mouth, four lans, each with two lights on each network. 1 reset button, 1 WPS key, 1 PWR indicator, 1 WLAN indicator, 1 power socket. 1) the CPU lights flashed, indicating that the router was working properly. 2) the PWR light is always bright, indicating that the router has been energized. 3) WAN: WAN interface (rj-45), connected to xDSL Modem/Cable Modem or Ethernet, after being connected The corresponding indicator is always bright. 4) LAN: LAN interface 4 (rj-45), computer and hub/switch through these interfaces Domain net, the corresponding indicator light is always bright after the connection. Power: this one is for you to connect to the Power supply. If you want to restore factory Settings, hold the Reset button for 5 to 10 seconds. The system will be automatically restored to the factory The default value. Be careful not to press the reset button unless you want to clear the current information 2.2 hardware installation steps Connect the power of the ipTIME N300R. Connect the routers WAN port to the xDSL Modem/Cable Modem or the width provided by the community With the interface. To connect the computer to the routers LAN, use a double stranded cable connection. For wireless connection, check if your wireless card is enabled. If you dont have wifi enabled Card. The following is the ipTIME N300R network topology: N300R network diagram Chapter 4 quick setup wizard To use the router properly, you must do the right configuration for the router, and the following steps are to guide you Some basic configuration, and the next chapter introduces you to some of the details of the router. Chapter 3 quick setup wizard To use the router properly, you must do the right configuration for the router. Here are the steps to guide you With some basic configuration, the next chapter introduces you to