NICE3000故障处理方法（国外英文资料）.doc

NICE3000故障处理方法（国外英文资料） Synchronous well channel self-learning E35 Scene description: after learning from the shaft, the elevator will be reported to the E35 every time after study. Problem: the NICE3000 synchronizer except the PG card (MCTC - pg-b), the link between the two (via CN6) is the basis for the system recording of the rotatory encoder pulse, but not A corresponding to PGA; B corresponds to PGB, which is related to the setup of the unit. So the control system is in the course of the well self learning process, and the second level of the plateplate comes in, and the number of pulses recorded in the system is immediately prompt for E35 if it is 0 or negative. Rule of elimination: adjust the connection of PG to CN6. Check f4-03 to confirm the increase of pulse number in the upward direction of the elevator. In descending, the number of pulses is reduced. Appendix: all the causes arising from the E35 Before starting: 1, the current floor data of f4-01 are inconsistent with the lowest level of the f6-01 elevator. 2, the next level of forced deceleration is not valid. 3, F0 minus 00 = 0, open loop. If the buttons are always valid or open, the button will not be able to enter the self-learning operation. Running: 1, the repair switch is not in the repair position. The elevator will be reported to E35 if it runs in the same direction within the time period of the f9-02 setting. This parameter is less than 3S, which is invalid and not tested. If there is a super long floor well self-learning, the f9-02 parameter should be set to less than 3S, and when the learning is completed, it will be changed to 45S. 3, the floor height is less than 500mm. At the end of the study, the floor is not aligned with the highest level. 3, after the synchronous machine stops and holds the brake, the elevator lifts the car Scene description: in the process of the synchronization machine, it is found that the car has the feeling of sliding car while the lock is held at the same time. The