oki5100f打印机乱码解决办法（国外英文资料）.doc

oki5100f打印机乱码解决办法（国外英文资料） The printer prints out the mess. The reason is very complex, the simple discriminant method can take your printer to another computer to try to see if can be normal printed is garbled, if print is normal, then prove fault and host, or the one on the other computer using normal printer connected to try it on your computer, if the normal fault and your printer. After the appearance of a mess, you can check it in a soft way: Software solution 1. Change printer parallel port mode in the BIOS Settings (if you are using the traditional printing line instead of USB printing line), enter the BIOS, Integrated peripheral to the parallel port mode, has the following four patterns SPP (the standard parallel port), EPP (enhanced parallel port), ECP (extended parallel port), ECP + EPP, if your printer model is old, set for SPP mode is recommended, and the current mainstream printers set to ECP + EPP mode is recommended several patterns (of course you also can try). 2. Stylus printer, printer and paper including ordinary needle printer to print two modes, LQ simulation and himself if the pattern of use is not correct, print is also likely to be garbled phenomenon (in the printer properties can change the print mode). 3. The printer driver installation may lead to incorrect or damage to the print gibberish, reinstall the latest printer driver, driver installation is completed the test page prints out an executable to test the printer is normal. There is no installation or damage to the font that is used for printing. 5. Software conflict, the use of pirated software, will cause the driver is not normal, lead to print the code, even some genuine software, due to the requirement on the print mouth install encryption dog, can also lead to abnormal print. Viruses cause printing anomalies, and sometimes the presence of a virus causes the printing of scrambled codes and anti-virus software to kill them. 7. System files against damage or loss caused by printing o