南天pr2打印机的手册及基本操作（国外英文资料）.docVIP

南天pr2打印机的手册及基本操作（国外英文资料） Southern day pr2 printers manual basic operation Southern day pr2 printers manual basic operation Print self-check (for every printer repaired) Turn off the power. Hold the Station2 key on the operating panel and turn on the power until the printer initializes the action. Insert an A4 size piece of paper into the middle of the paper slot, where the printer automatically aligns the paper to the correct print position. Then the loop prints out a test configuration table. L parameter Settings Turn off the power. Hold the Station1 and Station2 key on the operating panel at the same time, and then turn on the power until the printer initializes the action. Insert an A4 sheet of paper into the sink. The printer begins to suck up paper and prints out two lines of prompt information. Press the Local key once, and the printer enters the set state. If you press the Station1 key, recognize and save the parameters; If you press the Station2 key, change the parameters until the parameters you need to change or set are set. 7. After the parameter change, according to a Local key, press Station1 again, hears the printer send two clear and crisp, turn it off. (at this point change good parameters saved) Monitor the refresh of the program Connect the printer to the COM1 of the host. Open the top of the printer, hold down [STATION1] and [LOCAL] key, and cover the top. Run FLASHPR2 VXXX on the host. The printer will be downloaded by 8 modules and will be checked once after downloading. Before resetting, you need to restore the factory parameter and set it. The connection of the l printer to the host Main engine (9 hole) printer (25 pin) 2 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 2 3 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --