XO21VF 电梯各子系统故障记录解释（国外英文资料）.doc

XO21VF 电梯各子系统故障记录解释（国外英文资料） The XO21VF elevator subsystem failure record interpretation OCSS fault record 1100 Software reset (Software reset) : occurs when Software executes too long, internally The monitor enables the software to resume execution. 1101 Ring software reset: no group control information is received at any given time. Make the group control communication resume. 1200 the SIO message framing error (information structure detection error) : by the MCSS transmitted to the data information of OCSS, detects an error structure, may be caused by power or communications lines disconnect. 1201 SIO timeout error (information timing failure) : interrupt or pause in information sent to OCSS by MCSS. 1, 1300 RSL1 loss of synchronisation: the cars serial communication line loses synchronization while transmitting information. 1301 RSL2 loss of synchronisation (the hall communication is out of sync) : the serial communication line in the hall has lost synchronization while transmitting information. 1302 RSL3 loss of synchronisation: group control serial communication lines lose synchronization while transmitting information. 1400 RSL1 total parity errors: the data parity error was detected on the serial communication line of the car. 1401 RSL2 total parity errors (hall communication parity error) : the data parity check error is detected in the main hall serial communication line. 1402 RSL3 total parity errors (group control communication parity errors) : detecting data parity errors in a group control serial communication line. 1, 1500 RING1 checksum error (RING1 detection failure) : detected fault in RING1 group control. 11501 RING1 timeout error (RING1 timing failure) : in RING1 group control communication When the fault. 1700 MCSS not available (MCSS communication failure) : MCSS cant communicate with OCSS. 1701 Car shutdown while in EPO: when emergency rescue was made using the backup power supply, the elevator failed. 1702 DTC protection count: the elevator ca