如何设置电脑停电后一来电就自动开机（国外英文资料）.doc

如何设置电脑停电后一来电就自动开机（国外英文资料） How to set up a computer without a power failure. Listed below depending on the BIOS setting methods: 1, the first to enter the Power Management Setup (Power Management Settings) - Power Again calling back (state), this determines the accident after Power on startup, Power supply recovery system Power state. Change the Power Management Setup option Keyboard Power On to Enabled, so that you can turn On the Power On the Keyboard. Automatically start on 09-10 after power failure [in the 3, some BIOS POWER MANAGEMENT SETUP] without saying [PWRS Lost Resume State], can be in [PWRON After PWRS - Fail] - [Integrated Peripherals] options found in two options: ON (open automatically boot) and OFF (shut down automatically boot), is set to OFF. Different main board and the BIOS model corresponding to the options will be different, but I guess it should be, generally in the [POWER MANAGEMENT SETUP] this option can be found in the corresponding Settings! The computer turned on F1s solution of the year 2011-03-30 1: boot press the Del key, enter the BIOS Settings, select the first basic Settings, set the floopy A no Disabel invalid. 2: at first press Del to enter BIOS when the phone is switched on, press the enter key to enter the first, see if the item Drive A inside None, if not in accordance with the Pgup or PgDn modified, the modified according to the ESC, choose Save Exit Setup and press enter to Exit the BIOS, restart, again not line, you can change the battery again according to the above steps to reset can be. How do you cancel the boot and press F1? The 2011-01-23 ikanbai This shows that the BIOS Settings are flushed out and the BIOS (again called the CMOS setup) is reset. The BIOS Settings of various motherboards are different and can be adjusted by reference to your main board. The CPU has been changed please re-enter CPU Settings in the cmos setup and remember to save before quit! Some motherboard has a frequency jump line, the default is