安全装置常见故障和处理方法（国外英文资料）.doc

安全装置常见故障和处理方法（国外英文资料） Displacement sensor, weighing sensor, light screen sensor, flat layer sensor, velocity coder, etc. The third part Common failures and handling of safety devices one Stop circuit failure The phenomenon of Stop relay ( Voltage relay ) Dont suck.  why In the emergency power line of the elevator, the coils of the stop relay are generally closed to the following safety switches In series, such as bottom-hole emergency stop switch, speed limiter switch, safety window switch, car top urgent stop switch, sedan chair Stop switch, safety clamp switch, Phase-sequence relay contact The towing motor relay contact, owing to magnetic relay Contact, Steel band switch, etc., Any of these switches will break off the relay coil Electrical discharge, which makes the control circuit of the elevator fail to start.  Processing method 1. Check for the cause of the failure of the safety switch and repair it. 2. Maintain safety switch on a regular basis As a reliable. In operation, it is absolutely forbidden to use wire short switch contact, which causes the elevator to run.  2 Limit switches do not fall  The phenomenon of The elevator is at the end of the pole and the car is not able to touch the limit switch.  why The tension between the car is too large or the pressure is less than the limit On the switch ratchet, the switch cant pull down.  Processing method Adjust the gap between the car and the wheel, and make it suitable for the production of wire rope Theres enough tension to transfer to the limit switch.  Adjust the required 1. When the elevator is slower than the end point, Limit switch should be sensitive. 2. Limit switch When the action is done, the distance between the lower and upper end of the car is the distance from the upper and lower part of the car 50 ~ 200 mm .  3 Door interlock switch failed  The phenomenon of The door lock relay is closed and closed.  why Because the lock relay coil is connected to the door lock of the various floors, th