当电脑不能自检 主机不能正常启动问题集---经验谈[精华]（国外英文资料）.doc

当电脑不能自检 主机不能正常启动问题集---经验谈[精华]（国外英文资料） When the computer cant self-check, the host cant start the problem set properly 1, power switch failure When the power switch button for aging cannot reset or chassis front panel because deformation cause not timely reset after the power switch button, use the switch has been switched on state, then can appear after pressing the power switch, host to add electricity to start, but automatic shutdown after 4 seconds. If the circuit of the power switch is short, when we plug in the power supply, the main engine will be activated, and then automatically shut down after four seconds. Inspection method to unplug after boot connected to the motherboard PW_ON interface panel switch, directly with a small screwdriver short jumper, observe whether the host is also 4 seconds off problems. If the fault disappears, the switch circuit can be determined. The RESET switch or jumper is short-circuited Although few opportunities for such a failure occurs, but with the increase of computer use time, non-locking button switch used by a RESET button will appear because of the elastic failure after press cant bounce, cause always on state; Or because the button on the front panel of the cabinet is not in place or deformed, causing the RESET button to be pressed down and not RESET in time. Again, because of our maintenance, pull, unintentionally caused the connection to be short. At this time, when we press the power switch, remain the state of reset because the mainboard, although the utility has been switched on, the CPU fan and power supply fan, graphics card fan, main fan are starting to work, but the host didnt have any startup. If we have a DEBUG card inserted in the PCI slot, we immediately notice that the RESET lamp is always bright, and we can immediately determine that there is a short connection between the RESET relative power supply. There is a memory failure Memory chips or malfunctioning of the resistance capacity, can appear sometimes