数显电压表与电流表电表接线图（国外英文资料）.doc

数显电压表与电流表电表接线图（国外英文资料） Three-phase power supply respectively by meter 2,5,8 coil voltage into the line, each corresponding to the K1 tap current of transformer coil into the terminal 1,4,7, K2 tap corresponding ammeter into terminal, current meter at the other end connect 3,6,9 watt-hour meter current coil output end, then 3,6,9 parallel earthing. The current meter is finished. Reconnect the voltmeter, the three-phase power supply is connected to the three terminals of the input line of the voltage meter switch. The voltmeter will be connected to the output of the voltage table switch. Three-phase power supply respectively by meter 2,5,8 coil voltage into the line, each corresponding to the K1 tap current of transformer coil into the terminal 1,4,7, K2 tap corresponding ammeter into terminal, current meter at the other end connect 3,6,9 watt-hour meter current coil output end, then 3,6,9 parallel earthing. The current meter is finished. Reconnect the voltmeter, the three-phase power supply is connected to the three terminals of the input line of the voltage meter switch. The voltmeter will be connected to the output of the voltage table switch. Ask warrior Can this transformer k1 meet current meter into the side And then from out side into the meter 1 in 3 three transformer transformer k2 directly into electricity meter can meet in this order? Is it correct to be grounded in parallel? Thank you answer also can, as long as the transformer, current meter, electricity meter current coil is three series, transformer one-point earthing can, outlet and inlet line of them have a direction, an anti ammeter pointer will reverse, dont show the correct current size. You are asked to ask for further trouble, 3.6.9 parallel grounding. I put 3.6.9 in connection to the meter no. 10 is not a grounding? Thank you for the neutral grounding system, the 10 is also grounded, and the 3, 6, 9 and the 10 are grounded. Transformer received terminal from the ammeter respectively, and the S1