新时达SM-01-F输入输出接口说明（国外英文资料）.doc

新时达SM-01-F输入输出接口说明（国外英文资料） The new time dsm-01-f input output interface specification The new time dsm-01-f input output interface specification New time elevator input and output interface definition: JP1, JP2, JP3 is the external switch signal input, JP1.1: enter X0, repair signal, disconnect to repair, and close to automatic (input type immutable) JP1.2: enter the X1, uplink. Close to the point when the service is on, and close to the upturn when the driver is on. (the input class is immutable.) JP1.3: enter X2, the downward signal. Close to the point when the service is on, and close to the downward (input class immutable) when the driver is closed. JP1.4: input the X3, upward multilayer terminal in speed switch, 2 meters per second Above requires the use of the elevator, (input type can be changed, the factory value is normally closed, low speed elevator without this signal, please set the input type X3 is normally open) X4 JP1.5: input, downlink multiple terminals in speed switch, 2 meters per second Above requires the use of the elevator, (input type can be changed, the factory value is normally closed, low speed elevator without this signal, please set the input type X4 to normally open) JP1.6: enter X5, the upward limit switch (input type can be changed, factory value is often closed contact) JP1.7: enter X6, the downstream limit switch (the input type can be changed, the factory value is often closed contact) JP1.8: enter X7, the upstream single-tier terminal change switch. (input type can be changed, factory value is normally closed contact.) JP1.9: enter X8, lower single-tier terminal switch. (input type can be changed, factory value is normally closed contact.) JP1.10: enter X9, top layer dry spring (input type can be changed, factory value is always open contact) JP2.1: enter X10, bottom layer dry spring (input type can be changed, factory value is always open contact) JP2.2: enter X11, the governors fault output signal (input type can be changed, the