星玛NEW DSS故障码（国外英文资料）.doc

星玛NEW DSS故障码（国外英文资料） No Open Door. - please confirm that the door limit switch and the closing limit switch are ON, and you can confirm the limit switch ON the variable menu. -check the door, please. 4 No Input feel SW - does not enter the door switch. -please check the door machine and the door switch. No Input DCL - cant enter the closing limit switch. - please check the closing limit switch. No Close Door. -check the door, please. 7 UL on-ul moves. - below the top level, the upper level switch is unable to move. -check the position or switch of the limit switch. SUSL has moved before SUSL On the top of the top. - please confirm the IPM5 setting time. - please adjust the location of USL or set time for IPM5. CODE is the column description of the text 9 USL ON -usl action. - please adjust the location of USL. HUSL on-husl action. - adjust the HUSL position. VHUSL on-vhusl action. - please adjust the position of VHUSL. 12 MHUSL on-mhusl action. - please adjust MHUSLs position. 13 DL ON -dl action. - at the lowest Level Level, the DL is unable to move. -check the location or switch of DL. 14 SDSL ON - before the minimum level of deceleration, SDSL has moved. - please confirm the timing of IPM4. - adjust the location of the DSL or the set time of the IPM4. 15 DSL ON - DSL action - adjust the location of the DSL. HDSL ON - HDSL action. -please adjust the location of the HDSL. 17 VHDSL ON - VHDSL action. - adjust the location of the VHDSL. 18 MHDSL ON - MHDSL action. -adjust the location of the MHDSL. The maximum elapsed time for a layer to run. - please confirm GPM1 time. Level 20 - cant start. 21 Over Stop - after all the levels, it stops. -- on PPM, set the speed bump a little longer. 22 Small Over - the Level stops. -- on PPM, set the speed bump a little longer. 23 LowCreep Speed - didnt get to the crawl. If you crawl slowly, reduce the speed limit by a little. - set the speed of the creep higher. Inverter Fault - a converter error occurred. -check the frequency cha