硬盘逻辑损坏和物理损坏修复（国外英文资料）.doc

硬盘逻辑损坏和物理损坏修复（国外英文资料） Hard disk failures can be divided into logical damage and physical damage. If its a logical break, the big name FORMAT, reload software. For physical damage, if there is a bad way, if the situation is not particularly severe, it is generally possible to solve the problem if appropriate measures are taken. What is it that shows physical damage to the hard disk? 1. When reading a file or run a program, the hard disk and read repeatedly error, it would take a long time to succeed, or hard disk will be emitted strange noise at the same time, this phenomenon shows that the hard disk is bad. 2. Start by hard disk boot the system, with a floppy disk boot after can turn to the hard disk drive, but unable to enter, in SYS command transmission system cant succeed. This is likely to be a problem with the boot sector of the hard drive. When the FORMAT hard drive stops, it stops at some point and ends up being unable to complete it. When you execute FDISK on your hard drive, you go back and forth on a certain schedule. In general, you can try to fix a small number of hard drives in the following order. Start with the simplest way. If can enter Win9X system, in the my computer, right-click the hard disk drive in the shortcut menu select properties, in tool box to the hard disk scan completely, and the possible bad cluster automatic amendment. For more than 2 kinds of circumstances which could not enter Win9X phenomenon, you can use Win9X startup disk to start the machine, and then in A: prompt after typing SCANDISK D: (the D is the specific hard drive) to scan the hard disk. For the bad variety, the program will be marked in the red letter bad. 2. Because Win9X is largely automatic repair bad logic, and cannot be automatically repair physical bad, so, in fact 1 kind of method often cant work. So, we can mark these bad paths, not to use them, and to be far away from them. Remember the location of the bad path in the first method, and then the FORMAT of the h