375调试费希尔定位器（国外英文资料）.docVIP

375调试费希尔定位器（国外英文资料） Use the 375 field communicator (manual operator) to check DVC6020 quick start 1, 375 and the HART loops connection 375 can communicate with any terminal connector in the control room, instrument field or circuit. The HART connection is not sensitive to polarity when the 375 and the appropriate connector are connected to the meter or load impedance. To make sure that 375 is positive Often work, at least 4mA current and 12VDC voltage in the on-site device terminal (in this case DVC), HART The impedance in the circuit must not be less than 250 ohms. There are three ports on the top of 375. Two of them are red, one is black. The two red ports are the pros of their respective protocols. The black port is the common side of the two protocols. The protective cover ensures that only a pair of ports are exposed at any time, as shown below. There are multiple tags, which indicate which pair of ports corresponds to which protocol, and the DVC on the anti-surge valve is HART. Launch the 375 type field communicator After the HART circuit is connected, to the DVC signal (a signal sender or a PLC/DCS power card), To ensure normal communication, the DVC must have at least 4mA current at 12VDC voltage. Press open/key, until the multi-function LED indicator is flashing, indicating that the device has been on (for about two seconds). The open/key location is shown in figure 2-2. During startup, 375 will automatically install all the upgrade software on the system card. When finished, you will display the main menu for 375, which you can select HART Application (start HART Application) FOUNDATION Fieldbus Application (launch FOUNDATION Fieldbus Application) Setting (configuration/viewing Settings) 4, Listen For PC (enter PC control mode) ScratchPad (start ScratchPad app) 3, shutdown when the application opens, the key is disabled. Before using the open/key, you must return to the main menu of 375. If you want to close the 375, hold open/key until the display is clo