PC3000修复西部数据硬盘故障总结（国外英文资料）.docVIP

PC3000修复西部数据硬盘故障总结（国外英文资料） One of WDs maintenance WDEB, AB, BB, JB, and AD hard disk firmware First, put the bad hard drive on IDE2; Do not jump the safety mode, use the test version of the efficiency source twice, regardless of success. Use the ERASE command in MHDD to complete the whole thing twice. Reuse the WD hard disk to make a safe mode and repair it. Then take the corresponding module in PC3000V12. Use 1-2-1-2 this method is the sector regeneration recovery, restart. 7, use MHDD to see if it is normal. If not normal, enter the corresponding module of PC3KV12 again, use internal formatting inside, choose two. 9, use the last item, G and P, to repair it. Using this method, you can fix the A S, S error codes and A small amount in the MHDD! Wd2000eb-00csf0 maintenance record 20Gs WD hard drive can be detected but not activated. With the cd-rom boot, the partition is missing and the FDISK partition is not available. Enter DISKGEN and PQ for error, not partition. You cant use DM and LFORMAT. We have to use the F4 function of MHDD, all of which are blue S. Using HDDREG1.3 in the first lattice is a long time. If you dont have the patience to wait, you quit to use PC3K. Go to PC3K. Before this, jump the hard disk to safety mode. The first is the scan firmware, which appears to show several errors 2, the inside is low, is the one that doesnt consider G heel P, feel very slowly at the beginning of low, only to pop up a hint, read 30 this number:). I waited impatiently, and dropped out. 3, is the choice of the fourth menu, is the logical scanning defect what setting has not changed to press enter directly, after the scan has over a thousand errors. After 4, exit the PC3K with DM tried fertilizations, finally can lower case, but I dont have low case, try the PQ with DISKGEN, partition is no problem, I use FDISK test points and the area again, OK, but in the process of the FORMAT in bad way. And then you use PC3K again. Now were using the lower case, which is the lower c