喷墨打印机故障完美解决大全（国外英文资料）.doc

喷墨打印机故障完美解决大全（国外英文资料） The inkjet printer failure perfectly solves the complete. TXT Printer output blank paper Causes of printing paper blank for stylus printer, mostly because of the ribbon ink dries up, pulled ribbon, print head damage, etc., should be timely replacement ribbon or repair the print head; For inkjet printers, print blank failure is mostly due to the nozzle blocking, ink cartridges, ink, etc., should be cleaning nozzle or replace the cartridge, if the modified continuous ink, also may be the outer air holes of the cartridge did not open, should be put out with air holes on the ink cartridges. For the laser printer, not the cause of the fault may be developing roller suction to the toner (dc bias by developing roller), may also be a photosensitive drum off ground, make the negative charges are unable to release, a laser beam to work on the photosensitive drum. In addition, the laser printers light-sensitive drum does not rotate, and no image is generated and uploaded to the paper. Disconnect the printer power, remove the ink cartridge, open the slot on the lid of the box, make a mark on the non-sensitive part of the sensitive drum and reload the machine. Turn on the operation for a while, and then remove the check mark and see if it is working properly. If the toner cannot be properly supplied or blocked by a laser beam, the phenomenon of printing blank paper will also appear. Therefore, it is necessary to check whether the toner is used, whether the ink cartridges are properly loaded, whether the sealing tape has been removed or if there is a covering in the laser channel. It is important to note that you must turn off the power when checking, because the laser beam may damage the operators eyes. Second, the printing paper is black For stylus printer, the cause of the malfunction is the ribbon hair removal, excess ink on the ribbon, the print head, smudgy, poor quality of ribbon and the push rod position too close, and so on, maintenance should firs