灵敏度公式（国外英文资料）.docVIP

灵敏度公式（国外英文资料） Bring these values into and use the equation: Sout/Nout = Eb/No * Rbit/BRF gets the output signal-to-noise ratio: 5dB - 25dB = -20db. This means that the expanded bandwidth system is actually working under negative SNR. In order to obtain the maximum receiver noise coefficient (denoted as NFmax) for the sensitivity of the minimum rule, the receiver sensitivity equation is used: Sin (dBm) = NF (dB) + KTBRF (dBm) + Eb/No (dB) -pg (dB) The following steps and figure 2 give you a specific way to get NFmax: Step 1: for the WCDMA system, the maximum required sensitivity of the rf input signal is -121dbm. Step 2: subtract 5dBs Eb/No value, and the maximum noise level allowed in the user band is -126dbm (12.2 kHz). Step 3: add the processing gain of 25dB and get the maximum allowable noise level in rf carrier bandwidth for -101dbm. Step 4: subtract maximum allowable noise from rf input noise and get NFmax = 7.1 dB. Note: if the receiver used in the design of more efficient detector, makes the requirement of Eb/No value for only 3 dB rather than 5 dB, under the condition of the receiver NFmax 7.1 dB, receiver sensitivity can be achieved - 123 DBM. In addition, the NFmax value as high as 9.1 dB can also be tolerable by lowering the requirement for the Eb/No value to the maximum required input signal - 121dBm. summary Use derived from the definition of noise figure of receiver sensitivity equation, the designer can weigh in spread spectrum link budget and determine the parameters of the receiver, it is feasible to arbitrary input signal level, then the equation is very useful in determining the system sensitivity. Sin (dBm) = NF (dB) + KTBRF (dBm) + Eb/No (dB) -pg (dB) The meaning of Ec/No, Eb/Nt, and Eb/No E is a short for Energy, and c is a Chip, which is a Chip in 1.2288 Mcps, and the Ec is the average Energy of a Chip, and notice the Energy, The units are joules. I is short for Interfece, and o is short for Other Cell, and Io is the meaning of interference f