teac说明书.docVIP

teac说明书 篇一：TEAC录音座说明书 TEAC V-5010录音机英文说明书 important(for U.K. customers) The wires in this mains lead are colored in accordance with the following code: Blue: neutral Brown: live As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: The wire which is colored blue must be connected to the terminal which is marked with the letter N or colored black. The wire which is colored BROWN must be connected to the terminal which is marked with the letter Lord colored RED. In the U.K, this unit is sold without an AC plug. 1. Power switch press to switch the deck on, the display window will be illuminated. Press again to turn the deck off. note: WHEN SWITCHING THE POWER ON AGAIN AFTER SWITCHING IT OFF,BE SURE TO WAIT FOR MORE THAN 3 SECONDS. 2.REMOTE SENSOR(Remote Control infrared Signal Receptor)this receives signals from the provided RC393(v-5010) infrared remote control unit. 3. Linear counter Indicates recording and playback time in minute and second. 4. Mode indicator CD sync: lights when cd synchro start is activated. Rec: lights in the recording mode and flickers during record muting. Play: lights during playback and recording. Pause: lights when the tape is stopped temporarily. 5. Clear button Pressing the clear button resets the linear counter to aero (0000).press this button before starting recording or play back. 6. Tape length button Set this to minimize the error in the counter reading. (See page7.) 7. RTZ button if this button is pressed, the tape is fast forwarded or rewound until a counter reading of 00M00S is reached, then the deck stops.(see page 9) 8.Cassette Holder load the cassette here. 9.auto monitor button to change the monitor mode between source and tape, press this button. the monitor mode is automatically selected in accordance with the tape operation. 10.mpx filter button press this button when making a re