MEDICAL GAS MIXTURE - Flotec - Manufacturers of ….docVIP

INGAGE SERIES HIGH PRESSURE MEDICAL AIR REGULATOR FLOTEC INC Web Site: 7625 West New York Street 317-273-6960 Fax 317-273-6979 Order desk: 800-401-1723 Indianapolis, Indiana 46214-4911 e-mail:flotec@ Order desk Fax 800-515-9254 The FLOTEC INGAGE Series high pressure medical air regulator w/ INGAGE is designed to provide a constant flow of medical air at approximately 50 PSI. In addition, the FLOTEC INGAGE Series regulator can simultaneously deliver a measured flow through the twelve-position selector. The FLOTEC regulator is preset to deliver approximately 50 PSI through the optional DISS check valve(s) or the flow selector outlet which can be either a hose barb or a DISS fitting. Every FLOTEC INGAGE series regulator has an internal safety relief valve to prevent over pressurization of the regulator. The main connections available is the CGA 347 nut and nipple (connector). FLOTEC products contain no latex or latex byproducts. SPECIFICATIONS: REPLACEMENT PARTS: Operating Pressure: 250-5500 PSIG Outlet Pressure: Nominal 50 PSIG DISS-1160 Fitting Flow Capacity: Minimum: 1 LPM, Maximum: 60 LPM Diss-1160 Check Valve thru the 12 position selector Hose Barb 100 LPM thru optional DISS-1160 check valve(s) Piston/Manifold sub-assembly Inlet Configuration: CGA 347 Nut and Nipple (Connector) O-Ring for CGA 347 Nipple (Connector) Outlet Configuration: Hose Barb DISS-1160 Fitting DISS-1160 Check Valve Flow Meter Assembly INSTALLATION: CGA 347 Connector: Mount the regulator to a CGA 347 cylinder valve. Be careful to avoid cross-threading the connection. To achieve a proper seal for threaded cylinder connections, which use a gasket, or O-Ring be sure the gasket or O-Ring is properly positioned before attaching the regulator to the valve. INSTALLATION: Pipe Connector: Use only Teflon tape on the threads as a sealant. INSTALLATION: The Flot