基于STC单片机的虚拟IIC软件包(改自周立功软件包)(外国英文资料).docVIP

基于STC单片机的虚拟IIC软件包(改自周立功软件包)(国外英文资料) # include reg51. H # include intrins. H # define uchar unsigned char / * macro defines * / Pound sign define uint unsigned int Extern void Delay1us (unsigned char); Sbit SDA = P1 ^ 6; / * simulate I2C data transfer bit * / Sbit SCL = P1 ^ 7; / * simulate the I2C clock control bit * / An ack bit; / * reply mark bit * / / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Starting bus function Function prototype: void Start_I2c (); Function: start the I2C bus, which is the I2C start condition. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / Void Start_I2c () { SDA = 1; / * sends the data signal * / Delay1us (1); SCL = 1; Delay1us (5); / * initial conditions are established over 4.7 us, delay times SDA = 0; / * send the initial signal * / Delay1us (5); / * the initial condition lock is greater than 4 mu s * / SCL = 0; / * clamp down on the I2C bus, ready to send or receive data * / Delay1us (2); } / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * End bus function Function prototype: void Stop_I2c (); Function: end the I2C bus, which is the end of the I2C. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / Void Stop_I2c () { SDA = 0; / * send out the data signal * / Delay1us (1); / * the clock signal for the end condition. * / SCL = 1; / * the end condition is more than 4us / Delay1us (5); SDA = 1; / * send the I2C bus stop signal * / Delay1us (4); } / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Byte data send function Function prototype: void SendByte (uchar c); Functions: send the data c out, address