现浇楼板(外国英文资料).docVIP

现浇楼板(国外英文资料) The main points of the cast-in-place floor Method a The channel steel is the main beam, the Angle iron purline, the above spot welding decorative pattern steel plate, and then in the dozen of the cement mortar ground floor of the cement mortar This production requires that the stairs have the steel girder that is welded to the channel before construction The construction advantage, the period is quick, but the cost is slightly higher Method 2 The channel steel foundation, the Angle iron auxiliary link, the spot welding screw steel, and then in the beating of a layer 8 centimetre and so on cement mortar The cost is slightly lower, but the construction cycle will take about 10 days to remove some of the roof and maintenance The design and cost of the construction scheme of the attic floor are discussed Attic floor hanging method There are three ways of hanging the attic floor: channel steel, workpiece steel, floor, carpet or tile (cement filling floor). 8, matters needing attention: 1, if you have no confidence to channel fixed, must be in the position of the rail mounted to the vertical to the ground of the u-steel support, have a fixed rail in, doesnt need channel steel vertical support every article main keel, under the condition of no more than 6 m, there were two or three root support line side. The steel bar itself should not be two pieces of welding, it must be one. If your interior plane is not square, but other polygons, it should be handled according to the above principle. If necessary, consult a professional structural engineer. The construction method of reinforced concrete attic It is suitable for the concrete, if the original design is permitted. The price is moderate, the quality is reliable, the life is long. Concrete floor is permanent, generally use fixed number of year is 70, so need to carefully before making a floor completes the design and layout, of course, that is about the design of the high advocates find some has a design capa