500程控(国外英文资料).docVIP

500程控(国外英文资料) Err1: the power supply fluctuates beyond the rule (over plus or minus 10%) 1, the voltage fluctuation of the external supply voltage does exceed 10% The solution: Ask the user to ask the local power supply unit (for example, the power supply bureau) for help. The user is able to invest in the supercharger. If the external power supply is more than 10% or more, it is stable enough to buy the voltage regulator. In the case of the voltage stabilizer, the voltage regulator must be installed to adjust the lock circuit, otherwise the console and the voltage regulator will be damaged. In the power supply board (plate 1), the power supply sampling value exceeds the range (DC11V ~ DC9V). Solution: check whether the voltage between R1 and R1 in the power panel is between dc 11V ~ 9V, and can be satisfied by adjusting the potentiometer R2. V = V / 380 x 10 (V in the current measured network voltage) The power supply panel (plate 1) has a circuit failure before the source sample point (R1 and R2) Solution: check the components in the circuit before the resistance R1 and the potentiometer R2. For example, transformer T1, silicon bridge V1, insurance tube F1, diode V2, etc. Replace the damaged components. Power failure of + 15V in the power supply plate (plate 1) Solution: check whether the power panel test TP10 voltage is normal (plus or minus 15V + + 0.5v ~ + 0.0.1 V). When the voltage is too low, there may be a short circuit within the machine, or LM338 (LM7815), damaged, repaired or replaced. The parts of the power board (plate 1), D1, D2, V7, V8 work anomalies Solution: check D1, D2, V7, V8 each point working voltage, judge the device of work abnormality, give change. Parts of the interface between the power board (plate 1) and the computer board (board 8) are abnormal The solution: Examine whether the connector between the power board (plate 1) and the computer board (plate 8) is reliable and repair the unreliable points. Check the voltage of 1, 2, 16 and 15 i