ANSYS接触问题专题(国外英文资料).docVIP

ANSYS接触问题专题(国外英文资料) ANSYS special contact problem Contact the general classification The contact problem is a highly nonlinear behavior, needs great computational resources, in order to compute effectively, to understand the characteristics of the problem and establish the reasonable model is very important. There are two major difficulties of contact problems: first, before you solve the problem, you dont know the contact area between the surface contact or separate is unknown, this sudden change, as load, material, boundary conditions and other factors; second, most of the contact problem need to calculate the friction, there is several kinds of friction and models for you to choose from, they are nonlinear, the friction convergence problem becomes difficult. Contact the general classification The contact problem is divided into two basic types: rigid flexible body contact, semi flexible flexible body contact in the contact problem of rigid flexible body, the contact surface of one or more as a rigid body, (compared to the deformation of contact with it have much larger stiffness). In general, a soft material and a hard material contact, problems can be assumed to be a rigid flexible body contact, many metal forming problems for such contact, on the other hand, the soft body flexible body contact, is a more common type, in this case, two the contact is deformed (approximate stiffness). ANSYS contact capacity ANSYS supports three kinds of contact modes: point to point, point to surface, the plane surface contact element, use each contact for a class of problems. In order to contact problem modeling, must first recognize what part in the model may be in contact with each other, if one of the interactions is a model, the opposition should element is a node. If one of the interactions is a plane, the corresponding model of component unit, such as beam element, shell element and solid element, the finite element model by specifying the contact element to identify possi