东莞小成叉车培训叉车保养与维修一(国外英文资料).doc

东莞小成叉车培训叉车保养与维修一(国外英文资料) Domestic forklift temperature anomaly inspection and repair 1, check the thermostat The thermostat at the engine with wax type thermostat. The main performance is in different water temperature thermostat should have different lift. In order to dynamically control the cooling water temperature. The disintegration of the cooling system to check the thermostat is mainly through the radiator temperature difference between inlet and outlet of the judge. In the engine cold starting some time ago, the inlet and outlet of touch should have obvious difference, after working for a long time, the temperature was significantly reduced. When the engine at normal operating temperature (80 DEG -90 DEG) when the touch has no obvious difference in feeling. Of course, the most accurate method of detecting or remove the thermostat, the hot water, gradually heating, check valve opening temperature and valve lift. 2, check the water pump The power source of circulating cooling water in the cooling system continuously from pump. Pump can build enough pressure is the key to the normal operation of the cooling system. In addition of cooling water, if the engine speed increasing, the coolant level decreased significantly, indicating that the pump is working properly. On the other hand, it may pump and impeller loose, cooling water can not circulate. In the domestic forklift engine, generator, water pump, cooling fan uses a belt, so the belt tightness directly affect the water pump, fan, generator speed. The middle finger pressure belt, deflection should be 11-13mm (CPC3L model) is the lead as normal, the water temperature is too high, too small will cause damage to the pump bearing, generator bearing. 3, cooling fan Detection of the air volume of the fan can be a thin paper placed in front of the radiator, when the engine is running, if the paper can be blown open, the air is enough. The front engine car fan and inward suction difference. Leaves can not be reversed