低温离心液体泵的操作(国外英文资料).doc

低温离心液体泵的操作(国外英文资料) Operation of low temperature centrifugal liquid pump ? Application of cryogenic liquid pump The main separating pump and plunger pump of cryogenic liquid pump, the centrifugal pump is large and the pressure is low, the plunger pump is low and the pressure is high. The use of oxygen plant is widely used, mainly for the liquid oxygen adsorber or the circulating liquid oxygen pump in the process. The circulating coarse liquid argon pump in the non-hydrogen argon process (the high level of the high demand liquid pump); The product liquid oxygen, liquid nitrogen, liquid argon pump in the inner compression process (low in general flow, with plunger pump). ; Filling pump (plunger pump) Tank charging pump Peak supply pump and so on. Two, cavitation and gas plugging Centrifugal liquid pump will happen sometimes row out, outlet pressure rise not up or large fluctuations, impact fluid in the pump, pump body also produces vibration, even causes the liquid pump cant continue to work. This phenomenon is known as the gas plug of a liquid pump, which is caused by a large amount of evaporation in the pump. Cavitation is different from gas plugging and cavitation is a kind of damage to pump. When the centrifugal pump is running, the pressure inside the impeller is different, the inlet pressure is lower, the outlet pressure is higher. And the gasification temperature of a liquid is associated with stress; The lower the pressure (or the higher) the corresponding gasification temperature (or higher). If the liquid enters the pump and the temperature above the imported pressure corresponds to the gasification temperature, then some of the liquid will vaporize and form a bubble. And when the bubble was liquid to a high pressure area, due to the corresponding gasification temperature increase, the steam will condense into liquid again, bubble burst quickly. At this time, due to the density of gas and liquid are hundreds, so at the instant of the bubble condensation, sudd