原料磨中控操作规程(国外英文资料).doc

原料磨中控操作规程(国外英文资料) In the control of raw material mill operating procedures.Txt12 missing is a poem to let you in ordinary days to read out the rhythm; missing is a shower, let you dry up the moist days; missing is a sun, so that your days of gloomy clear up. 5000t/d production line of Nanzhao Tianrui Group Cement Co. Raw material grinding Operating rules Tianrui group India Cements Limited Nanzhao trial Operation regulation of raw material grinding 1 Purpose This procedure is for Tianrui group India Cements Limited Nanzhao firing raw mill in factory control operation prepared, its purpose is to make the control with the kiln operation can complete the production tasks, the control operation standardization, to ensure the qualified production clinker required material. 2.1 quality requirements 1: 0.08mm) the fineness of square hole sieve over less than 15% 2) the grinding of water is less than or equal to 0.5% 3) three rate values are controlled according to quality control requirements 2.2 process parameter requirements 1) the inlet temperature of the grinder is 180~250 degrees centigrade 2) inlet pressure of mill is 200 ~ 1000Pa 3) the outlet pressure of the mill is 6500~8000 Pa 4) the temperature of the mill outlet is 80~90 degrees centigrade 5) pressure of sealing fan 30mba 6) the inlet and outlet pressure difference of the mill is from 5000 to 5500Pa 7) vibration mill is less than or equal to 2.5mm/s 8) the thickness of material layer is 60 ~ 100mm 9) the range of water spraying in mill is 10% ~ 100% 10) grinding pressure 86 ~ 120bar 11) the inlet temperature of the dust collector at the kiln is 90~150 degrees centigrade 12) the temperature of the dust collector at the end of the kiln is 90~150 degrees centigrade 13) the inlet pressure of kiln dust collector is -2000 ~ -2500Pa 14) the negative pressure of the dust collector at the end of the kiln is -3500 to -4000Pa 15) the outlet temperature of the humidifying tower is 180~220 degrees centigrade 16) the tempera