如何使用ghost备份硬盘(国外英文资料).docVIP

如何使用ghost备份硬盘(国外英文资料) How to use ghost to backup the hard disk One, what is Ghost? Ghost software is the United States Symantec Corp launched an excellent backup backup tool, you can achieve FAT16, FAT32, NTFS, OS2 and other hard disk partition format partition and hard disk backup and restore. Commonly known as cloning software. Features: 1, now known as cloning software, the Ghost backup is based on the hard disk sector as a unit, that can be a complete physical information on the hard disk copy, rather than simply copying data; clone only clone body, but this Ghost can all what cloning system, including the sound animation image, even can help you copy disk fragments. Ghost supports backing up partitions or disks directly into a file called.Gho extensions, and also supports direct backups to another partition or hard disk. 2, running Ghost: so far, ghost only supports Dos running environment, this cannot be said is not a kind of regret: (. We usually copy the ghost file to start the floppy disk (U disk), it can also be recorded into the boot disk, the boot disk into the Dos environment, type ghost at the prompt, enter ghost to run, the first is on the interface, press any key to enter the ghost interface, ghost menu, the main menu a total of 4, from the bottom to the top are Quit (exit), Options (Peer to, Peer (optional) point of the network, mainly used) and Local (local). Normally we only use the Local menu item, which contains three sub items: Disk (hard disk backup and restore), Partition (disk partition backup and restore), Check (hard disk detection), before the two functions we use the most, the following is the interpretation around these two expansion. 3, because the Ghost in the backup and restore is by sector to replicate, so be careful when operating, dont put the target disk (partition) has made a mistake, or will the target disk (partition) data will erase all very miserable...... Theres not much chance of recovery, so be serious and careful! But yo