手动配置 IPv6(国外英文资料).docVIP

手动配置 IPv6(国外英文资料) Manually configure IPv6 Author: Cable Guy For a list and more information about all of the columns hosted by Cable Guy, click here. In most cases, IPv6 hosts running Windows XP or Windows Server 2003 do not need to be manually configured. In some cases, however, you must manually configure the IPv6 address for the computer. In addition, sometimes a computer has a special effect on the network. The following sections describe how to configure IPv6 for the following objects manually: ? Manually configure the IPv6 address. ? IPv6 router. ? 6 to4 router. ? Automatic tunnel addressing protocol (ISATAP) router in the site. ? 6 over4 router. Content on this page Manually configure the IPv6 address IPv6 router 6 to4 router ISATAP router 6 over4 router For more information Manually configure the IPv6 address Windows XP and Windows Server 2003 family of IPv6 protocol support stateless address autoconfiguration, using this protocol, the address, routing, and other configuration parameters based on the received the Router Advertisement (Router) to automatic configuration. However, if you want to configure IPv6 address (do not use the router) or any cast address, such as any cast DNS address, you can use the netsh interface IPv6 add address command to manually configure IPv6 address. The syntax for this command is as follows: Netsh interface ipv6 add address InterfaceNameOrIndex IPv6Address [[type =] unicast | anycast] [[type =] [[preferredlifetime =] Minutes |] [[] By default, the address type is a single (unicast), the valid and preferred lifetime is infinite (infinite), and the address is persistent (persistent). To get the interface name or its index, you can use the display of the netsh interface IPv6 show interface command. For example, configure the site Local address FEC0 on the interface called the Local Area Connection: 1A49:2AA: FE34: CA8F, the corresponding command is: Netsh interface ipv6 add address Local Area Connection Fec0:1 a49:2aa: fe34: ca8f