教你怎样使用万用表 应用技巧全解析(国外英文资料).doc

教你怎样使用万用表 应用技巧全解析(国外英文资料) How do you use all the multimeter application techniques Selection of pointer tables and digital tables: 1, the read pointer table accuracy is poorer, but the process of pointer swing is more intuitive, the swing speed range can sometimes more objectively reflect the size of the measured (such as TV measurement data bus (SDL) in the slight shaking when transmitting data); Digital reading is intuitive, but the process of digital change looks cluttered and difficult to watch. Two batteries, a low voltage 1.5 V, a high voltage 9V or 15V, a black pen is the positive end of a red pen. The digital watch USES a 6V or 9V battery. In resistance, pointer table pens and output current is relatively much larger Numbers table, can make the speaker in R x 1 Ω gears a loud sound da, using R x 10 k Ω file can even light emitting diode (LED). In the voltage, the indicator is relatively small and the measuring accuracy is poor. Some high voltage micro current situation cannot even measure, because of its resistance to affect the circuit being measured (such as when measuring the acceleration of the TV picture tube voltage level measured value is lower than the actual value will be many). The internal resistance of digital table voltage is very large, at least at megabit, which has little effect on the measured circuit. But the high output impedance makes it susceptible to induced voltage, and the data that can be detected in the more electromagnetic interference may be false. In short, a pointer table, such as a television set and a stereo amplifier, is applied to the analog circuit measurement of high current voltage. Digital meters are used in digital circuit measurements of low voltage and low current, such as BP, cell phone, etc. It is not absolute, but it is possible to select a pointer table and a digital table. Two, measuring skills (i.e., a pointer table) : 1, speakers, headphones, moving coil microphone: R x 1 Ω file, any pens and connect one end, a