水利工程协会质量检测员继续教育 金属结构检测试卷(国外英文资料).doc

水利工程协会质量检测员继续教育 金属结构检测试卷(国外英文资料) Total score of test paper: 100 Exam time: 100 minutes Remaining time: 98 minutes and 41 seconds Examination paper for metal structure engineering Individual choice questions (1 points per game, 40 points) (1) after the completion of the assembly of the movable gantry crane and the portal frame, the mid span camber is (). One (0.9 ~ 1.4) L/1000 (1 ~ 1.4) L/1000 (1.1 ~ 1.4) L/1000 (2) the limit deviation of grid spacing rack for the design space (). Two + 3% + 5% + 8% + 10% (3) the position tolerance of mushroom head center of miter gate should be no more than () mm. Three One One point five Two Two point five (4) after the installation of miter gate, the gate () shall be adjusted under the condition of free suspension of the gate (2) The pivot column and diagonal pillar Crown tie bar Back tie rod Bottom beam (5) when the load test of the rake type cleaning machine is carried out, the volume (twice) of the raking bucket shall be taken in the grab position of the raking bucket, and the raking bucket shall be taken for 3 times. Three Two Three Four Five (6) the comprehensive error of the load limiter of rotary cleaning machine should not be greater than () 2 2% 5% 8% (7) all connections shall be checked before and after power up test, and the insulation resistance of line shall be greater than () M ohm. Two Zero point one Zero point five One One point five (8) the surface temperature of the base metal shall not be lower than the dew point of the atmosphere during surface pretreatment and painting. Two -3 C 3 C 5 C 10 C (9) fixed winch hoist shaft coupling hole surface area of not more than a single defect (mm2), the depth is less than the nominal wall thickness (%), the number of defects is not more than 2, and the distance between the two adjacent defects of not less than 50mm, can be considered qualified. Three 2010 2510 2520 (10) the working environment temperature of headstock gear shall be (). Three -15~+35 -15~+40 -25~+40 -25~+35 (