电缆桥架安装注意事项(国外英文资料).docVIP

电缆桥架安装注意事项(国外英文资料) Notes on installation of cable tray 1 、 the maximum load of the new alloy plastic cable tray equipment, the support spacing should be less than the allowable load and span. 2, the selection of cable bridge width should have some spare space, in order to add cable for future use. 3, when the power cable and control cable quantity is less, can use unified cable bridge installation, but in the middle to use partition board will Power cables and control cables are separated and laid out. If necessary, a shielded bridge shall be combined with a common bridge. 4 when the cable bridge is horizontally laid, the joints between the bridges shall be located at the 1/4 of the span as far as possible, and the bridge with the horizontal direction shall be located as far as possible Stand at about 2 meters high fixed boom one, the vertical direction of the bridge every 1.5 meters or so fixed one. 5, shield cable bridge installation should be equipped with protective cover, bridge in outdoor installation, the top should also be equipped with protective cover, prevent sun and rain. A device in substation (or power plant) including directly with production and distribution to related equipment for a device: generator transformer, isolating switch, transformer, power capacitor, reactor, busbar, lightning arrester, transmission lines, etc.. H E$a$D (D (n), v4CP3J0, connected by a primary device, is called a primary system. ZG power automation bGUw*t|K^ Two equipment of an electrical equipment for measurement, control, monitoring, control and protection of the auxiliary equipment, including: various relays, signal devices, measuring instruments, control switches, control cables, power supply operation and small bus etc.. A1F VVd0 {[consists of two devices connected into a loop called the two loop. ZG power automation Y7w6`GP+@G The task of the two circuit is to reflect the working state of the primary system, to control the primary system, and to make the accident pa