金属特性手册(国外英文资料).docVIP

金属特性手册(国外英文资料) Handbook of metallic properties Structural steel property: 08F has the advantages of cold plasticity, easy forming, good welding property, aging sensitivity, machinability, cold drawing and normalizing Better than annealed. 10, cold plastic good, plate normalization or high temperature back, performance and good, cutting, cold drawing, normalizing is better than annealing, Weldable. 35, cold plasticity is good, all kinds of welding performance is good, good machinability; for the production of small mechanical zero Parts and small and medium-sized forgings. 45 medium carbon high strength steel, hardenability is low, the general use of normalized, only the high demand parts Perform ML4 line conditioning. Cold plasticity in general; machinability, annealing, normalizing is better than quenching and tempering; suitable for hydrogen Welding and argon arc welding, gas welding is not suitable for. 20Cr, carburizing steel has higher hardness, worse toughness than 15CrA, and the grain tends to grow up when carburizing. 38CrA, Quenched and tempered steel, steel final heat treatment for quenching and tempering, good machinability, poor weldability. 25CrMnSiA, Quenched and tempered steel, with good plasticity in the annealed state, permits bending of complex shapes and hammering arches, Stamping; electric arc welding and welding hydrogen atom welding, gas welding and welding, especially qualified, arc Welding and hybrid welding, open crack tendency is small; machinability is good. 40Cr, tune The strength and yield point of hardened steel are much higher than that of 45 steel after quenching and tempering, and their hardenability is compared Well, the shape of the parts is complex. It is easy to crack when hardening in cold water, so it is advisable to quench in the oil; There is a great temper brittleness; surface hardening can also be done when the work surface of the component is required to wear Cyanide treatment. When cold deformation, the plasticity is medi