开工方案(国外英语资料).docVIP

开工方案(国外英文资料) Device operation method Preparation before commencement Organize relevant personnel to check and accept all maintenance items of the plant. 1. the workshop shall arrange special persons to remove or install all blind plates according to the blind plate. 2., to fully implement the program and requirements of workers, and process changes. 3. comprehensive cleaning device sanitation. 4. prepare fire fighting equipment and fire the steam belt. 5. clean out the sundries in the furnace, turn off the fire window, the explosion door and the manhole, and install the burner. 6. contact the supply department to receive ammonia water, lubricating oil, demulsifier, and corrosion inhibitor. 7. contact the inspection workshop for quality analysis of lubricating oil, ammonia water and lye, and provide the following analysis results to the workshop: Lubricants: viscosity, moisture, mechanical impurities. Ammonia water: concentration. 8. contact inspection workshop to provide crude oil analysis data: Specific gravity, water content, and en distillation data. 9. contact the plant dispatching room to bring in circulating water, fresh water, electricity, steam and compressed air inlet. 10. install the calibrated pressure gauge and thermometer according to process requirements. 11., the day before the start, each machine, pump, fan tank loaded with lubricating oil. 12. prepare heating furnace ignition rod. 13. prepare demulsifier solution with a concentration of 2%. 14. prepare the post record and shift diary. 3.2 inspection prior to commencement of work 1. tower 1. check tray, receiving tray, draw or return tower line, tower bottom and draw mouth, no sundries. 2. check whether the tray and its fasteners are firm, whether the tray level is qualified or not, whether the float valve is complete and flexible. 3. check the distribution pipe, the steam distribution pipe opening is smooth, the direction is accurate. 4., check the pressure gauge, liquid level gauge pipe is smooth,