【2017年整理】射出成形课程四.pptVIP

第二單元 射出成形條件之介紹 ;塑料之乾燥;塑料之乾燥;塑料之乾燥;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;塑膠射出成形之乾燥條件;射出成形條件之設定;射出成形條件之設定;射出成形條件之設定;射出成形條件之設定;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;射出成形條件之設定;射出成形條件之設定;射出成形條件之設定;射出成形條件之設定;射出成形條件之設定;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;1. 材料的乾燥與模溫的設定;;壹. 制程參數設定要領;2.3 鬆退 在計量結束后的瞬間,螺杆適當抽退(無背壓,不旋轉)可以降低在螺杆前端塑料的壓力,熔融的塑料較不易由噴嘴滴漏,熱流道系統的模具亦可