Avr单片机基于ATmega16的按键数码管程序.docVIP

按键数码管程序 // Target : M16 // Crystal: 4.0000Mhz #include iom16v.h #include macros.h #define huang1 (PINBBIT(PB0)) #define huang2 (PINBBIT(PB1)) #define huang3 (PINBBIT(PB2)) #define huang4 (PINBBIT(PB3)) unsigned char xianshishuju[8]; unsigned char key=16; //16 表示无效键值 void port_init(void) { PORTA = 0xff; DDRA = 0xff; PORTB = 0xff; DDRB = 0xf0; PORTC = 0x00; //m103 output only DDRC = 0xff; PORTD = 0x00; DDRD = 0x00; } //call this routine to initialize all peripherals void init_devices(void) { //stop errant interrupts until set up CLI(); //disable all interrupts port_init(); MCUCR = 0x00; GICR = 0x00; TIMSK = 0x00; //timer interrupt sources SEI(); //re-enable interrupts //all peripherals are now initialized } // void delay(unsigned char m) { unsigned char i,j; for(i=0;im;i++) for(j=0;j570;j++); } unsigned char const duanma[]={ 0XFC,/*0*/ 0x60,/*1*/ 0xDA,/*2*/ 0xF2,/*3*/ 0x66,/*4*/ 0xB6,/*5*/ 0xBE,/*6*/ 0xE0,/*7*/ 0xFE,/*8*/ 0xF6/*9*/}; void baweixianshishuju(void) { unsigned char i; for(i=0;i8;i++) { PORTC=~BIT(i); PORTA=duanma[xianshishuju[i]]; delay(1); PORTA=0X00; } } void main(void) { unsigned char i; init_devices(); //insert your functional code while(1) { // for(i=0;i10;i++)baweixianshishuju(); PORTB=0XEF; if(!huang1) key=3; if(!huang2) key=6; if(!huang3) key=9; PORTB=0XDF; if(!huang1) key=2; if(!huang2) key=5; if(!huang3) key=8; if(!huang4) key=0; PORTB=0XBF; if(!huang1) key=1; if(!huang2) key=4; if(!huang3) key=7; do{baweixianshishuju();PORTB=0X0F;} while(PINB!=0x0F); if(key10) { xianshishuju[0]=xianshishuju[1]; xianshishuju[1]=xianshishuju[2]; xianshishuju[2]=xianshishuju[3]; xianshishuju[3]=xianshishuju[4]; xianshishuju[4]=xianshishuju[5]; xianshishuju[5]=xianshishuju[6]; xianshishuju[6]=xianshishuju[7]; xianshishuju[7]=key; key=16; } baweixianshish