营销研究ASTM_A564A564-04_热轧及冷精轧时效硬化处理过的不锈钢棒材和型材技术规范.pdfVIP

Designation: A 564/A 564M – 04 Standard Specification for Hot-Rolled and Cold-Finished Age-Hardening Stainless Steel Bars and Shapes1 This standard is issued under the fixed designation A 564/A 564M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 2. Referenced Documents 1.1 This specification2 covers bars and shapes of age- 2.1 ASTM Standards: 3 hardening stainless steels. Hot-finished or cold-finished rounds, A 314 Specification for Stainless Steel Billets and Bars for squares, hexagons, bar shapes, angles, tees, and channels are Forging included; these shapes may be produced by hot rolling, A 370 Test Methods and Definitions for Mechanical Testing extruding, or forging. Billets or bars for reforging may be of Steel Products purchased to this specification. A 484/A 484M Specification for General Requirements for 1.2 These steels are generally used for parts requiring Stainless Steel Bars, Billets, and Forgings corrosion resistance and high strength at room temperature, or A 705/A 705M Specification for Age-Hardening, Stainless at temperatures up to 600°F [315°C]; 700°F [370°C] for Type Steel Forgings 632; 840°F [450°C] for Type UNS S