热采井预应力隔热管柱最佳胀率设计.pdfVIP

3 1 5 Vol. 3 1 No. 5 2 010 9 A CT A PETROLEI SINICA Sept. 2 010 :( 2 010) 050 84 90 5 闫相祯 张殿锋 王同涛 杨秀娟 ( 257061) : 根据预应力隔热管在制造下入和注蒸汽等工况下的受力变形特点, 建立了基于 佳胀率原理的隔热管内外管设计计算力 学模型, 推导出相应工况下隔热管在井口和井底封隔器位置处的 大胀率 小胀率和比例胀率的计算公式利用Visual Basi 语 言编制了相应的计算软件, 对胜利油田多口热采井预应力隔热管进行了计算分析, 得到了不同下入深度和注汽温度时隔热管 佳 胀率设计值结果表明, 佳胀率设计方法可以满足注蒸汽条件下隔热管强度设计要求; 在下入工况下, 井口隔热管内外管胀率随 下入深度增加而线性减少; 在注汽工况下, 隔热管的胀率要比下入工况下的增加显著; 建议在隔热管胀率设计时要以注汽时隔热管 受力为基准, 采用比例胀率方法进行设计 : 注蒸汽井; 隔热管柱; 预应力设计; 比例胀率; 力学模型 : T E2 6 : A Design of the prestressed insulation tube in thermal recovery wells by the optimum expansion rate method YAN Xiangzhen ZHAN G Dianfeng WANG T ongtao YANG Xiujuan (College of A rchitecture Storage Engineering, China University of Petroleum, Dongying 2 570 61, China) Abstract: A omputational me hani s model for designing prest ressed inner or outer insulation tubes w ith opt imum expansion rate was built up a ording to their hara teristi s of the for e load and deformation during different ourses of manufa t ure, running in and st eam inje t ion. Cal ulat ing equations of the max imum expansion rate, minimum expansion rate and proport ional expansion rate of the insulation tube at well head or w ellbottom pa kers w ere dedu ed based on this me hani s model. A softw are ompiled by the Visual Basi omput er language was applied to al ulate the optimum designed expansion rate at either different depths of running in or different t em perat ures of steam inje t ion by analyzing prestressed insulation tubes of many horizontal wells in the Shengli Oilfield as an ex ample. The omprehensive results show ed that the approa h to design the optimum expansion rat e by this paper ould satisfy designed