沈阳理工大学 高频电子线路new.doc

《高频电子线路》教学大纲 课程代码：030631012 课程英文名称：High-Frequency Electronic Circuits 课程总学时：64 讲课：56 实验：8 上机：0 适用专业：通信工程 大纲编写（修订）时间：2012.09 一、大纲使用说明 （一）课程的地位及教学目标 本课程是通信工程专业的学生的专业基础课，是较重要的学位课程。该课程是一门实践性很强的核心基础课程，也是有关的工程技术人员和相关专业的技术人员的必修课程，它是研究无线电通信系统中的关于信号的产生、发射、传输和接收即信号传输与处理的一门科学。其先修课程有：《高等数学》、《电路》。《高频电子线路》电子工业出版社2010.01 《高频电子线路》第四版张肃文主编2004.11 《高频电子线路》高主编电子工业出版社2009.06 二、中文摘要 本课程主要是使学生掌握高频电子线路的基本理论、基本工作原理、分析设计高频电路的基本方法和基本的实验技能, 为下一步高频小信号谐振放大器高频功率放大器正弦波振荡器频谱的线性搬移电路振幅调制、解调及混频频率调制与解调1、通信系统组成 2、信号、频谱与调制及发射机和接收机的组成 3、课程特点、本书的研究对象及任务通信系统组成信号、频谱与调制及发射机和接收机的组成高频小信号谐振放大器 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be