日本验船师成套培训教材.pptVIP

dsskjlhkfd Acceptance Inspection for Brought-in Product Acceptance Inspection forBrought-In Product September 2004 Suppliers and acceptance inspection Scope of inspection Collation of ID number Endorsement on certificate (reverse side) ID stamp on steel plate, section, bar etc. ID stamp on steel plate ID stamp on angle ID stamp on anchor ID stamp on chain cable ID stamp on rope ID stamp on side scuttle ID stamp on propeller ID stamp on tarpaulin ID stamp on stern frame ID stamp on rudder stock ID stamp on rudder pintle Certificate for side scuttle Certificate for wire rope Certificate for steel plate (mill sheet) Plate arrangement Materials without NK certificate With certificate issued by IACS member Acceptable, in principle, subject to visual, chemical,non-destructive, chemical and mechanical test. Testcertificate will be issued. Without certificate Not acceptable. Test machine To be certified by NK or appropriate authority Inspection of anchor Manufacturing test process of anchor Drop test of anchor Hammering test of anchor Proof test of anchor Test process of propeller (1/3) Test process of propeller (2/3) Test process of propeller (3/3) Flash butt welded chain Bending procedure of a link Proof test of chain 　 　 検査の対象となる材料?艤装品のリストを提出してもらう。漏れている項目が無いか注意。 規則の対象は乾舷甲板上第三層まで。丸窓の他に、居住区（上部）区画壁や煙突用の鋼板も検査の対象外 証明書と現物とを照合すると共に、運送中に変形や疵を受けてないか調査する。 それぞれの板がどのブロックのどの部分に使われたかをミルシートに記載させる 検査員はその使用場所、サイズが正しいか否かの確認を行なう 型鋼についても同様 * casting heat treatment chemicalcomposition sampling oftest piece materialtest drop test hammeringtest visualinspection assembly ofcrown shank weightmeasurement proof test non-destructivetest dimensionmeasurement completion * Acceptance Inspection for Brought-In Product