5-LCD1602液晶驱动程序(国外英文资料).docVIP

5-LCD1602液晶驱动程序(国外英文资料) / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / / / = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = / / LCD1602 driver module program, which can be displayed normally, STC89C52 singlechip, 11.0592 MHZ vibration frequency / / its definition is as follows: / / sbit RS = P2 ^ 0; / / register selection, which defines the RS bit as P2.0 pins / / sbit RW = P2 ^ 1; / / read and write select bits, which define the RW bit as P2.1 / / sbit E = P2 ^ 2; / / enable the signal bit and define E bit as P2.2 / / sbit BF = P0 ^ 7; / / busy marker, which defines the BF bit as P0.7 / / = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / # include reg5.h / / containing the header file of the single-chip register # include intrin.h / / contains the header file defined by the _nop_ () function # define uchar unsigned char # define uint unsigned int Sbit RS = P2 ^ 0; / / register selection, which defines the RS bit as P2.0 pins Sbit RW = P2 ^ 1; / / read and write select bits, which define the RW bit as P2.1 Sbit E = P2 ^ 2; / / enable the signal bit and define E bit as P2.2 Sbit BF = P0 ^ 7; / / busy marker, which defines the BF bit as P0.7 Unsigned char code string [] = { 1602ir-code TEST }; Unsigned char code string1 [] = { test BE HAPPY }; / * = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = LCD1602 function definitions section = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = * / / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Function: delay 1ms * * * * * * * * * * * * * * * * * * * * * * *