line6 pod hd300 400效果器中文说明书(国外英文资料).docVIP

line6 pod hd300 400效果器中文说明书(国外英文资料) Line6 pod hd300 400 effector Chinese manual Chinese operation manual Setting up the details This section will detail how to set up the POD HD300 and POD HD400, how to correct the pedals and restore factory Settings. Setting options By setting up the menu, you can set the system. Once set, most of the Settings will stay the same for the next time you boot. And these Settings are all set, not changed by the default you choose. To enter the Settings menu, press the PRESETS button and use the direction key to navigate through the menu. The diagram below: Output mode -- the LIVE mode option Behind the HD300, there is an output mode to select a file, and the menu in the figure above is used to set up the sub-schema for the LIVE mode. There are four modes of choice: ComboFrt: the pre-input (default) to the box ComboAmp: the back level input connected to the one box StackFrt: the pre-level input to the header of the header StackAmp: the back level input connected to the header of the sorting box AutoFX AutoFX - Disabled: when selecting different speakers, you will not change the current effect chain Settings Autofx-ampsetfx: when selecting different speakers, the effect chain will automatically change from the factorys default value. USB to monitor the volume When the HD300 is used as a USB audio device, you can set up USB listening volume. The nail control mode selection There are two types of nail mode for preset, single block and loop function. Normal: Normal mode. In this MODE, every pedaled MODE switch in the three MODE transformation: default (green), one piece (yellow) and the phrase cycle (red) Hold4Lpr: in this MODE, only a long press MODE switch will enter the loop control MODE, leaving the loop in a single step. The instantaneous tap MODE will only change between the preset and one block MODE. AC Rate All POD HD speakers are emulated by alternating current sound, which is an important part of the sound of the tube speakers. The