T类数字功放的一些介绍(国外英文资料).docVIP

T类数字功放的一些介绍(国外英文资料) The power transistor in the D class is in the switch state, also known as digital amplification. A class A is good at fidelity, but it is very inefficient, less than 10%, for the high-end professional stereo. There is a slight difference in fidelity, but the efficiency can be between 20% and 40%, mainly for cars, home speakers and computers. Class D power amplifier efficiency is as high as 80% to 80%, dont need radiator when using, or only need A small radiator, but its fidelity compared with class A and class AB amplifier is far less. The ideal result is that the fidelity is high and the efficiency is high. Tripath Technology companies to provide a good fidelity, high efficiency of audio power amplifier, the power transistor is in the closed state of work, namely the class D, in order to distinguish it from using pulse width modulation principle design of class D power amplifier, Tripath refers to the audio power amplifier as the T type of power amplifier. In pulse width technology of class D power amplifier is poor quality, the reason is that: the output power is not pure switch transistor, also not match well, leads to distortion; When the transistor is switched on and off, the potential of the site will fluctuate, increasing the noise. Power output circuit is to use two power transistor (or four) connect the bridge road, a power transistor conduction, the other closed, between the dead zone; Power output circuit output with a low pass filter between the speaker and the audio content filtering, let the audio signal into the speaker, but not completely filter PWM carrier, this is also a factor of distortion. The power output circuit of the T class power amplifier is the same as the pulse width modulation D, the power transistor is also the work on the switch state, the efficiency and the D class are equivalent. Its different from the D, its not the way to use the pulse width. Tripath has developed a Digital Power Processing technology called D