主动变速箱阀体(国外英文资料).docVIP

自动变速箱阀体(国外英文资料) It is also understood that the automatic transmission system, hydraulic system and mechanical mechanism are closely related. Especially in the oil control valve steam pressure reducing valve and hydraulic system are precise and labyrinthine oil way like printed circuit board, different sizes of plunger, the length is not the same degree of spring, steel ball, plastic ball, mesh seat, spacing pieces, accumulator and appellation is multifarious, part direction, location, size is no flow. There must be detailed information on the body to be repaired, fully understood and examined. For the AT wave box, only when the serious damage of lining, planet gear wear, 1/4 vehicle mileage and ATF oil serious smudgyll consider to collapse body cleaning maintenance. The electrical control hydraulic automatic transmission, the oil road control valve body failure cause many is the inside dirty, clogging the oil road to cause. The cleaning valve body is an indispensable part of major repair automatic transmission. Before removing the body from the bottom of the gearbox, it is important to be careful when removing the external solenoid valve. Due to the electromagnetic valve joint on one side of the flat line for plastic products, long-term immersion in the ATF oil, high temperature is very brittle, application of homemade special tools, completely inserted into the solenoid valve plug below, and follow the direction to remove the plug and wiring harness, properly placed, appearance under, take off, remember the original position, the body in the kerosene soaking time, and then remove the empty net. (2) placed on the body clean bench, pull down the connection between the body screw, will hold the body of the upper and middle clapboard and stability, at the same time together over middle clapboard up (the move can make a one-way ball wont fall), then picked up the plate for next work. Remove the diaphragm, prior to the demolition in the body of the plunger should take a