主板、电源、显示器 维修日记(国外英文资料).docVIP

主板、电源、显示器 维修日记(国外英文资料) 2009.3.28 The Great Wall 300 w + P4 power supply Failure: restart automatically after the start of the restart Test main power supply two switch tube 13009 normal, auxiliary power supply switch tube also normal, + 5VSB normal, TL494.12 feet voltage is normal All electrolytic capacitors look good, the C945 is normal, full plate diodes and triode are normal. Solution: replace 13009, which is replaced by 13007, with low power and low voltage. Everything is normal after change. 2009.3.31 The lenovo computer, the model didnt notice Adopt the main board: MSI main board, type is not noticed Failure: automatic shutdown immediately after turning on Change the power source test first, the fault is still, the fault point is not power After the disassembly, there was a lot of dust in the memory slot, cleaned up and then tested, and the fault remained The quantity of ps-on voltage is 0.78, the quantity of the ATX socket is normal to the ground resistance, indicating that the power circuit has no short circuit or open circuit PCI - A14 foot voltage 3.3 V, standby voltage is normal, measuring battery voltage 3.0 V, normal Follow the ps-on line, the lights are too dark, and then give up halfway, and there is no door circuit, there are ms-6 boot chips, 83627WHF (not necessarily, anyway There are three of the suffixes, and you can shave your feet with a shot, and you dont have any virtual soldering, you know, its a rainy day, and its not going to be wet and its not going to be normal for the inside of the IC or the nearby circuit, Then the wind gun wind 4, the temperature 390, the blow 83627 chips and welding, two minutes later cooling, then the electric check, normal, not shutdown, strange, I all No formal repair, how come, I am so depressed that I can put a test card, get sick, and the C1 -25-26 cycle runs, and the heart sinks again Memory circuit has a problem, a memory core voltage 1.5 V, normal, can run to 25, should run to the graphics card, to the next l