主板维修笔记(国外英文资料).docVIP

主板维修笔记(国外英文资料) Related to the non-current board: In Nvidia chipset, TEST_MODE_EN (BGA internal circuits) signal by 1 k resistor to ground breaking 32.768 KHZ will appear and 25 m crystal oscillator, or only 25 m crystals in (will appear on both ends of the crystals are no voltage anomaly). The main plate of the NF4TS is R153, and if the R153 anomaly occurs in the first 25M, it will be a 25M low. 7rainbow P35 main board with CPU power and power failure, is bad for the BIOS data. Intel chipset: INTVRMEM affects electricity. High up to 945GCS no electricity, no 3.3 V S3 signal voltage, a low of I/O 75 feet RSMRST (only 65 euros for the ground dipole), which is caused by leakage of electricity to C102. The initial determination was that the C102 was not performing well after the external force, and after taking the C102, the I/O 75 foot resistance was restored to more than 600 ohm, and the fault was repaired. Jc61m main board (chipset is nf6100-430). The fault is not electric. S3 no 3.3 V voltage, for the screw hole on the back side resistance R175 is broken, and the end resistance meet SLP_S5 (out from inside the BGA), the other end connect MEM_VLD (out) from inside the BGA, the resistance for the inside of a BGA S5 loop resistance. Note: NF520 or 570 chipsets have the same resistance as R365 The high A78GT mainboard, 3.3 V SB voltage is low, less than 2V, changed the south bridge not good. Measure 3.3 V SB is only 33 o for the dipole, compared with good products 16 euro (good quality plate 49 o). Replace the 3.3 V conversion IC ASM1117 still bad, remove the card and I/O are not good, see the appearance after found that occurrence of the side has a 0603 patch capacitance C2 color yellow obviously, the capacitance is 3.3 V SB filter capacitor, after removed the capacitor C2, motherboard 3.3 V SB returned to normal. The main board of the N61S REV5.00 is not electric, the BGA is still after the BGA, and the BGA has a high resistance value (R175 should be 1 kilohm), and th